subject
Physics, 04.09.2020 01:01 needhelpwithHW10

When engineers design solutions to problems (bridge a river, support a building, etc.) there are always certain conditions which they must work under. For example, there may be a limit to funds, space, labor, or technology; or there may be environmental
restrictions to observe. These conditions are MOST GENERALLY referred to as design
A)
constraints.
B)
deprivations
C)
Limitations
D)
regulations

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 22:00
There is a theory that indicates that dinosaurs became extinct when about 65 million years ago, a large asteroid hit the earth surface. dust caused by this collision blocked the sunlight reaching the earth's surface and many forms of life became extinct due to the cold. fearing this threat, how large the radius of an asteroid should you be looking for if the dangerous asteroid size is approximately the same as the one that killed the dinosaurs? available data suggests that about 18% of that asteroid's mass ended up as a dust spread evenly over earth after eventually settling out of the upper atmosphere. about 0.0180 g/cm^2 of dust, which is chemically different than the earth's rock, covered the earth's surface. typical asteroids have a density of about 1.9 g/cm^3. now that we know the size of the asteroid, how much energy was released during impact, assuming all of it was just the kinetic energy of the asteroid right before the impact?
Answers: 1
question
Physics, 22.06.2019 09:50
Which statement correctly describes the current in a circuit that is made up of any two resistors connected in parallel with a battery? a. the current in the battery and in each resistor is the same b. the current the battery equals to the sum of the currents in the resistors c.the current in the battery is less than the current in either resistor d. the current in the battery equals to the product of the currents in the resistors
Answers: 1
question
Physics, 22.06.2019 11:30
Why is the energy that results from a roller coaster's position at the top of a hill referred to as potential energy?
Answers: 1
question
Physics, 22.06.2019 21:40
Engines for propeller-driven aircraft are limited in their maximum rotational speed by the fact that the tip speed of the propeller must not approach the speed of sound in air (mach i). taking 6 ft as a typical diameter for a propeller of a light airplane and 1100 fils as the speed of sound, find the upper limit on the rpm (revolutions per minute) of the propeller shaft.
Answers: 3
You know the right answer?
When engineers design solutions to problems (bridge a river, support a building, etc.) there are alw...
Questions
Questions on the website: 13722363