Physics, 05.09.2019 16:10 frisha

Physics students use a spring scale to measure the weight of a piece of lead. the experiment was performed two times: once in the air and once in water. if the volume of lead is 50 cm3, what is the difference between the two readings on the scale?

Answers: 3

Show answers

Another question on Physics

Physics, 21.06.2019 23:30

Edward tolman explained the results of his study by theorizing that the rats were learning about the maze during every trial but they a. were agitated because other groups were getting reinforcement b. could not remember how to demonstrate it without reinforcement c. were not motivated to demonstrate it without reinforcement d. seemed to be too lazy to actually work without reinforcement

Answers: 3

Answer

Physics, 22.06.2019 01:10

Asteam power plant operates on an ideal reheat rankine cycle between the pressure limits of 15 mpa and 10 kpa. the mass flow rate of steam through the cycle is 12 kg/s. steam enters both stages of the turbine at 500°c. if the moisture content of the steam at the exit of the low-pressure turbine is not to exceed 10 percent, determine (a) the pressure at which reheating takes place, (b) the total rate of heat input in the boiler, and (c) the thermal efficiency of the cycle. also, show the cycle on a t-s diagram with respect to the saturation lines. (2.15 mpa; 45.0 mw; 42.6%)

Answers: 3

Answer

Physics, 22.06.2019 02:50

Ammonia enters the expansion valve of a refrigeration system at a pressure of 10 bar and a temperature of 18oc and exits at 6.0 bar. the refrigerant undergoes a throttling process. determine the temperature, in oc, and the quality of the refrigerant at the exit of the expansion valve.

Answers: 3

Answer

Physics, 22.06.2019 12:30

Consider a 1000 w iron whose base plate is made of 0.5 cm thick aluminum alloy 2024-t6 (ρ = 2770 kg/m3 and cp = 875 j/kg°c). the base plate has a surface area of 0.03 m2. initially, the iron is in thermal equilibrium with the ambient air at 22°c. assuming 90% of the heat generated in the resistance wires is transferred to the plate, determine the minimum time needed for the plate temperature to reach 200°c.

Answers: 1

Answer

You know the right answer?

Physics students use a spring scale to measure the weight of a piece of lead. the experiment was per...

Questions