Engineering, 30.07.2021 01:50 maddigrace3
A cylindrical piece of 4140 steel is to be austenitized and quenched in mildly agitated oil. If the microstructure is to consist of at least 50% martensite throughout the entire piece, what is the maximum allowable diameter
Answers: 2
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
A cylindrical piece of 4140 steel is to be austenitized and quenched in mildly agitated oil. If the...
Social Studies, 01.07.2019 02:50
Mathematics, 01.07.2019 02:50
History, 01.07.2019 02:50
English, 01.07.2019 02:50
Biology, 01.07.2019 02:50
Physics, 01.07.2019 02:50
History, 01.07.2019 02:50
Biology, 01.07.2019 02:50
History, 01.07.2019 02:50