Engineering, 02.07.2021 04:30 vieraml58
Set the leak rate to zero and choose a non-zero value for the proportional feedback gain. Restart the simulation and turn on the outflow valve. What happens to the liquid level in the tank?Repeat this process with higher and lower values for the proportional feedback gain. What happens when the proportional feedback gain is increased?What happens when it is decreased?Find the proportional gain that will reach steady state the quickest without oscillationin the state of the valve and restart the simulation. What is the system time constant, as determined from the tank level versus time plot.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10
Asteam is contained in a rigid tank with a volume of 1 m3. initially, the pressure and temperature are 7 bar and 500 oc, respectively. the temperature drops due to cooling process. determine: (1) the temperature at which condensation begins in °c, (2) the fraction of the total mass that has condensed when the pressure decreased to 0.5 bar. (3) the volume in m3 occupied by saturated liquid at the final state?
Answers: 3
You know the right answer?
Set the leak rate to zero and choose a non-zero value for the proportional feedback gain. Restart th...
Questions
History, 26.03.2021 01:30
Social Studies, 26.03.2021 01:30
Advanced Placement (AP), 26.03.2021 01:40
Mathematics, 26.03.2021 01:40
Social Studies, 26.03.2021 01:40
Advanced Placement (AP), 26.03.2021 01:40
Mathematics, 26.03.2021 01:40
History, 26.03.2021 01:40
Mathematics, 26.03.2021 01:40
