Engineering, 30.04.2021 01:00 gabbym39077
Two technicians are explaining what exhaust gas emissions tell you about engine operation. Technician A says that the higher the level of CO2 in the exhaust stream, the more efficiently the engine is operating. Technician B says that CO2 levels of 20 to 25 percent are considered acceptable.
Answers: 3
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
Two technicians are explaining what exhaust gas emissions tell you about engine operation. Technicia...
Mathematics, 10.06.2021 17:20
Mathematics, 10.06.2021 17:30
Biology, 10.06.2021 17:30
Social Studies, 10.06.2021 17:30
Physics, 10.06.2021 17:30
Mathematics, 10.06.2021 17:30
History, 10.06.2021 17:30
Mathematics, 10.06.2021 17:30
Geography, 10.06.2021 17:30
Mathematics, 10.06.2021 17:30