Engineering, 21.12.2020 18:30 student8248

Propyl Benzhydryl Ether (continued on next page): (1) What volume of 1-pentanol is needed to convert 1.50 grams of benzhydrol to n-pentyl benzhydryl ether?
(2) Based on the results of this experiment, write a mechanism for the acid catalyzed reaction of benzhydrol with 1-pentanol to give the product from the last question. (Note: the mechanism is written on the first page of this experiment. You just have to figure out, based on the experimental results, which alcohol is ROH and which is R'OH and the write it using those two alcohols.)
(3) Under milder temperatures than what is needed for dehydration, strong acids catalyze the self-condensation of 1-propyl alcohol to give di-n-propyl ether. The mechanism differs from that of today's reaction in that the protonated alcohol undergoes an Sy2 rather than an Syl reaction. Write the mechanism for the acid catalyzed condensation of ethyl alcohol to give diethyl ether. Note: make sure your mechanism has the following three steps (a) protonation (b) Sx2 (not Syl) and finally (c) deprotonation.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

Answer

You know the right answer?

Propyl Benzhydryl Ether (continued on next page): (1) What volume of 1-pentanol is needed to conver...

Questions