Engineering, 16.10.2020 14:01 ptrlvn01

Cases of product are conveyed to automatic palletizers for palletizing. Depending on the particular product and carton dimensions, the palletizer has to be reprogrammed by an operator. Typically, 25 pallet loads are completed before reprogramming is needed. The reprogramming requires 4 minutes. The palletizer operates automatically for 40 minutes. The palletizer operator also must restock the machine with empty pallets; this can be done at any time during the last 10 minutes of the palletizer's automatic run time; restocking pallets requires 5 minutes. Travel time between palletizers, plus data entry in the computer system by the operator, requires 3 minutes. Required:
What is the maximum number of palletizers one operator can tend without creating idle time for the palletizer?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet

Answers: 3

Answer

Engineering, 04.07.2019 18:10

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

Answer

You know the right answer?

Cases of product are conveyed to automatic palletizers for palletizing. Depending on the particular...

Questions