subject
Engineering, 08.10.2020 09:01 lloveshan219

A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty of its facilities. Since the evaporation rates are very high in Palm Springs, it is likely they will need to pump a lot of groundwater to keep the pond full. The city has hired you (a water resources engineer) to determine how much water needs to be pumped per year in order to keep the pond filled. There is a small creek that discharges an average of 0.25 m3/s into the pond. The outlet valve from the pond releases an average rate of 0.30 m/s (to keep the pond from getting stagnant) Precipitation on the pond is 260 mm/year, and the annual evaporation is estimated to be 105 inches/year. The pond will be lined with concrete to prevent any drainage from the bottom .Using a water balance what volume on average of ground water must be added to take each year to keep the pound at constant level? Draw scematic of the problem to identify the control volume and relevent fluxes. Clearly write out or define your water balance equation and varibles along with any assumptions you make.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure
Answers: 2
question
Engineering, 06.07.2019 03:20
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
question
Engineering, 06.07.2019 03:20
Figure out the odd statement about ceramics in the following (a) good insulators of heat and electricity (b) usually less desire than metals (c) ductile in nature (d) contains both metallic and nonmetallic elements
Answers: 3
question
Engineering, 06.07.2019 04:10
Ir at sea level and 30°c and 50% relative humidity flows at a rate of 1 kg/s through a cooling coil that has an apparatus dewpoint of 10°c. the air leaves the coil at 15°c. determine the following: 3.1)- relative humidity of the air leaving the coil; 3.2)- moisture content of the air leaving the coil; 3.3)- sensible heat factor; 3.4)- total heat transfer rate; 3.5)- sensible heat transfer rate 3.6)- latent heat transfer rate
Answers: 1
You know the right answer?
A Palm Spring golf course has requested a permit to install a 40000 ft2 pond to enhance the beauty o...
Questions
question
Social Studies, 01.08.2019 03:20
question
English, 01.08.2019 03:20
Questions on the website: 13722367