Engineering, 15.07.2020 01:01 heysorryguys

Draw the and translate
chart beginn
The room
The following data apply to an A/C unit. Room sensible heat and latent heat are
11.6kW and 11.6 kW respectively, inside condition is 25°C DBT, 50% RH. Outside
design condition is 35 °C DBT and 27.8 °C, return air from the room is mixed with
outside air in the ratio of 4:1 before entering the cooler coil. Return air from the room
is mixed with the air leaving the coil in the ratio of 1:4. cooling coil bypass factor 0.1,
the air may reheated if necessary before supply to the room. Coil temperature is 10
°C. find a-supply air condition b- refrigeration load due to reheat c- total refrigeration
load capacity d- the quantity of fresh air supplied.
RSH. There
M2. sincet
we should
till this lir
intersectior
supply con
S
O MTW Mall
25°C, 50%
Qs=11.6
QI=11.6
R
R
R

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg.k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m.k

Answers: 2

Answer

You know the right answer?

Draw the and translate
chart beginn
The room
The following data apply to an A/C unit...

Questions