subject
Engineering, 17.04.2020 15:52 ximenareyna07

Water at a rate of 45,500 kg/h is heated from 80 to 150 ? C in a heat exchanger having two shell passes and eight tube passes with a total surface area of 925 m2 . Hot exhaust gases having approximately the same thermophysical properties as air enter at 350 ? C and exit at 175 ? C.

A) Determine the overall heat transfer coefficient.

he exchanger must heat 2 kg/s of water from 300 to 350 K, using 1.25 kg/s of combustion gases entering at 700 K.

B)

1. Using the overall heat transfer coefficient determined in the example, find the required heat exchanger volume, assuming single-pass operation.

2. What is the number of tube rows NL in the longitudinal (gas-flow) direction?

3. If the velocity of water flowing through the tubes is 100 mm/s, what is the number of tube rows NT in the transverse direction?

4. What is the required tube length?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
question
Engineering, 04.07.2019 18:10
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
question
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
question
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Water at a rate of 45,500 kg/h is heated from 80 to 150 ? C in a heat exchanger having two shell pas...
Questions
Questions on the website: 13722365