Engineering, 04.04.2020 11:12 stodd9503

A square power screw has a mean diameter of 30 mm and a pitch of 4 mm with single thread. The collar diameter can be assumed to be 35 mm. The screw is to be used to lift and lower a load of 7 kN. A coefficient of friction of 0.05 is to be used for friction at the thread and at the collar. Determine the following: (i) Torque required to raise the load, TR, (Equation 8.1) (ii) Torque required to lower the load, TL, (Equation 8.2) (iii) A conservative estimate of self locking condition is to set TL in equation 8.2 to zero and calculate the minimum coefficient of friction to ensure self locking. What is the minimum coefficient of friction to ensure self locking

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

When subject to a steady load (within elastic range) over a long period of time, what is the major difference in material behavoir between steel and plastic?

Answers: 2

Answer

You know the right answer?

A square power screw has a mean diameter of 30 mm and a pitch of 4 mm with single thread. The collar...

Questions