Engineering, 04.04.2020 10:42 billey32
A cylindrical rod of 1040 Steel originally 10.5 mm in diameter is to be cold worked by drawing to a final diameter of 8.5 mm. The circular cross section will be maintained during deformation. A cold-worked tensile strength in excess of 750 MPa and a ductility of at least 12 %EL are desired. Explain, with details and calculations, how this may be accomplished.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
You know the right answer?
A cylindrical rod of 1040 Steel originally 10.5 mm in diameter is to be cold worked by drawing to a...
Questions
Mathematics, 05.09.2020 04:01
Computers and Technology, 05.09.2020 04:01
Social Studies, 05.09.2020 04:01
Chemistry, 05.09.2020 04:01
History, 05.09.2020 04:01
Advanced Placement (AP), 05.09.2020 04:01
Mathematics, 05.09.2020 04:01
Mathematics, 05.09.2020 04:01
