Engineering, 11.02.2020 19:25 officialgraciela67

The following equation occurs in the solution of certain vibrations problems involving a constant cross-section beam with an end load, f(x) cx cot(x). It is necessary to find several, often hundreds, of the roots of this equation in computations of vibrational response of a given system. You are to find the first 25 positive roots of this equation using the bisection method. Write a MATHCAD program to accomplish this task. Taking c = 0.375
1. plot cot(x) and cx versus x.
2. use the results from the above plot to determine bracketing values for each of the first 25 positive roots of f(x)=0.
3. set the maximum error in determining the root to 10-5 and compute all 25 roots using five decimal places.
4. compare your results to those obtained by using the intrinsic root finding function in either MATHCAD or MATLAB.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.

Answers: 3

Answer

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 12:10

On a average work day more than work place firs are reorted

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

You know the right answer?

The following equation occurs in the solution of certain vibrations problems involving a constant cr...

Questions

Engineering, 22.08.2020 16:01

Experiment No.1 THE WOUND ROTOR INDUCTION MOTOR OBJECTIVE To examine the construction of the three-phase wound-rotor induction motor.