Engineering, 06.12.2019 21:31 cutie777
The extruder head in a fused-deposition modeling setup has a diameter of 1.25 mm (0.05 in.) and produces layers that are 0.25 mm (0.01 in.) thick. if the extruder head and polymer extrudate velocities are both 40 mm/s, estimate the production time for the generation of a 38-mm (1.5-in.) solid cube. assume that there is a 15-second delay after deposition of each layer as the extruder head is moved over a wire brush for cleaning. (4 points)
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
You know the right answer?
The extruder head in a fused-deposition modeling setup has a diameter of 1.25 mm (0.05 in.) and prod...
Questions
English, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
Mathematics, 20.05.2021 16:50
English, 20.05.2021 16:50
