subject
Engineering, 15.11.2019 04:31 samgirl2000

Air at 3.4 bar, 530 k, and a mach number of 0.4 enters a converging-diverging nozzle operating at steady state. a normal shock stands in the diverging section at a location where mach number is mx = 1.8. the flow is isentropic, except where the shock stands. the air behaves as an ideal gas with k = 1.4. d determine (a) the stagnation temperature tox, in k. (b) the stagnation pressure po, in bar (c) the pressure p, in bar (d) the pressure py, in bar (e) the stagnation pressure poy, in bar (f) the stagnation temperature toy, in k. (g) if the throat area is 7.6x10 m2, and the exit plane pressure is 2.4 bar, determine the mass flow rate, in kg/s, and the exit area, in mt answerl (a) 547.0k; (b) 3.796 bar; (c) 0.6607 bar; (d) 2.387 bar; (e) 3.086 bar; (f) 547.0k; (g) 0.498 kg/s and 10.99x10* m2.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 19:10
What are the major differences between injection molding and extrusion?
Answers: 2
You know the right answer?
Air at 3.4 bar, 530 k, and a mach number of 0.4 enters a converging-diverging nozzle operating at st...
Questions
Questions on the website: 13722360