Engineering, 29.10.2019 04:31 angelteddy033

We examined how an instruction is executed in a single-cycle data path. problems in this question refer to a clock cycle in which the processor (single cycle processor) fetches the following instruction word: 10101100011000110100.

assume that data memory is all zeros and that the processor’s registers have the following values at the beginning of the cycle in which the above instruction word is fetched:

r0 r1 r2 r3 r4 r5 r6 r8 r12 r31

0 -1 2 -3 -4 10 6 8 2 -16

a. what are the outputs of the sign-extend and the jump "shift left 2" unit (near the top of figure 4.24 from the book) for this instruction word?

b. what are the values of the alu control unit’s inputs for this instruction?

c. what is the new pc address after this instruction is executed?

d. for the alu and the two add units, what are their data input values?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

You know the right answer?

We examined how an instruction is executed in a single-cycle data path. problems in this question re...

Questions