Engineering, 18.10.2019 17:20 gumbyseth1969p45qjl

Consider that only a single tcp(reno) connection uses one 10mbps link which does not buffer any data. suppose that this link is the only congested link between the sending and receiving hosts. assume that the tcp sender has a huge file to send to the receiver, and the receiver's receive buffer is much larger than the congestion window. we also make the following assumptions: each tcp segment size is 1,500 bytes; the two-way propagation delay of this connection is 100msec; and this tcp connection is always in congestion avoidance phase, that is, ignore slow start.
a) what is the maximum window size(in segments) that this tcp connection can achieve?
b)what is the average window size(in segments) and the average throughput(in bps) of this tcp connection?
c) how long would it take for this tcp connection to reach its maximum window again after recovering from the packet loss?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection

Answers: 1

Answer

Engineering, 06.07.2019 02:30

In a unit cell of fcc structure, indicate the position of one of the tetrahedral interstitial sites by plotting the corresponding tetrahedron. do the same for one of the octahedral interstitial sites (in a separate fcc unit cell). mark the positions of all the tetrahedral and octahedral interstitial sites in the unit cells. how many equivalent tetrahedral sites and how many equivalent octahedral sites are contained in a fcc unit cell, respectively. what is the coordination number for a tetrahedral site and what is the coordination number for an octahedral site?

Answers: 2

Answer

Engineering, 06.07.2019 04:10

Aheat pump that operates on the ideal vapor compression cycle with refrigerant-134a is used to heat water from 15°c to 45°c at a rate of 0.12 kg/s. the condenser and evaporator pressures are 1.4 and 0.32 mpa, respectively determine: (a) the power input to the heat pump

Answers: 1

Answer

You know the right answer?

Consider that only a single tcp(reno) connection uses one 10mbps link which does not buffer any data...

Questions