Engineering, 05.06.2020 04:02 rbgrh5779

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 800 kpa and the temperature is 40 c to give mach no 2.5 the throat are for the nozzle is .0025m2 1- The flow rate through the nozzle under design conditions
2- The exit area of the nozzle
3- The design back-pressure and the temperature of air leaving nozzle with this back pressure
4-The lowest back-pressure for which there is only subsonic flow in the nozzle
5- The back-pressure at which there is a normal shock wave on the exit plane of nozzle
6- The back-pressure below which there are no shock waves in the nozzle
7-The range of back-pressures over which there are oblique shock waves in the exhaust from the nozzle
8- The range of back-pressures over which there are expansion waves in the exhaust from the nozzle
9- The back-pressure at which a normal shock wave occurs in the divergent section of the nozzle at a point where the nozzle area is half way between throat and exit plane the throat and exit plane areas.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Determine (a) the maximum thermal efficiency of reversible power cycles operating between a hot reservoir at 1000°c and a cold reservoir at 200°c and (b) the maximum cops for reversible refrigeration and heat pump cycies, respectively, between 28°c and 14°c.

Answers: 1

Answer

Engineering, 04.07.2019 19:20

Acircular pipe of 30mm outside diameter is placed in an airstream at 30 c and latm pressure. the air moves in cross flow over the pipe at 20 m/s, while the outer surface of the pipe is maintained at 110 c. what is the drag force exerted on the pipe per unit length? what is the rate of heat transfer from the pipe per unit length?

Answers: 1

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

You know the right answer?

Convergent divergent nozzle is designed to expand air at air from chamber in which the pressure is 8...

Questions