Engineering, 16.10.2019 20:00 daemonacoster

Asource has an alphabet {a1 , a1, a3, a4} with corresponding probabilities {0.1, 0.2, 0.3, 0.4}. 1. find the entropy of the source. 2. what is the minimum required average code word length to represent this source for error-free reconstruction? 3. design a huffman code for the source and compare the average length of the huffman code with the entropy of the source. 4. design a huffman code for the second extension of the source (take two letters at a time). what is the average code word length? what is the average number of required binary letters per each source output letter? 5. which is a more efficient coding scheme: the huffman coding of the original source or the huffman coding of the second extension of the source?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Analyze the factors that influence the choice between the following pairs of processes to make the products indicated: i) sand casting versus die casting of an electric-motor housing ii) thread rolling versus machining of a bolt for high-strength application. (co3/c5)

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

You know the right answer?

Asource has an alphabet {a1 , a1, a3, a4} with corresponding probabilities {0.1, 0.2, 0.3, 0.4}. 1....

Questions