Engineering, 14.08.2019 08:10 lizzyhearts
Acold-drawn aisi 1015 steel tube is 300 mm od by 200 mm id and is to be subjected to an external pressure caused by a shrink fit. what maximum pressure would cause the material of the tube to yield? . syt = syc = 600 mpa.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
You know the right answer?
Acold-drawn aisi 1015 steel tube is 300 mm od by 200 mm id and is to be subjected to an external pre...
Questions
English, 25.02.2020 20:16
Biology, 25.02.2020 20:16
Mathematics, 25.02.2020 20:16
Computers and Technology, 25.02.2020 20:16
Mathematics, 25.02.2020 20:17
