Computers and Technology, 28.10.2020 16:30 jalynholden07

What is copiedNums' length after the code segment? int[] originalNums = {1,2,3,4,5}; int[] copiedNums; copiedNums = copy(originalNums, 2); public static int[] cop

Answers: 1

Show answers

Another question on Computers and Technology

Computers and Technology, 22.06.2019 03:00

Check my work the microprocessor is a(n) circuit, which is designed to process data based on a set of instructions. most desktop and laptop devices contain a microprocessor based on the standard. most tablets and smartphones contain processors based on technology. a microprocessor's circuitry is designed to perform a limited number of tasks contained in its set. during processing, an instruction is loaded into the processor's unit. data is loaded into registers in the processor's where arithmetic and logic operations are performed. microprocessor performance can be measured by its speed. other factors affecting overall processing performance include word size, cache size, and instruction set complexity. most digital devices contain only one microprocessor chip, but today's multi- processors contain circuitry that supports parallel processing. computers contain various kinds of memory. random memory is a special holding area for data, program instructions, and the system. it stores data on a temporary basis until the processor makes a data request. ram is different from disk storage because it is , which means that it can hold data only when the computer power is turned on. computers also contain read- memory, which is a type of non-volatile memory that provides a set of "hard-wired" instructions, called the loader, that a computer uses to boot up.

Answers: 3

Answer

Computers and Technology, 22.06.2019 12:20

Usually, when we sniff packets, we are only interested certain types of packets. we can do that by setting filters in sniffing. scapy’s filter use the bpf (berkeley packet filter) syntax; you can find the bpf manual from the internet. set the following filters and demonstrate your sniffer program again (each filter should be set separately): (a) capture only the icmp packet. (b) capture any tcp packet that comes from a particular ip and with a destination port number 23. (c) capture packets comes from or to go to a particular subnet. you can pick any subnet, such as 128.230.0.0/16; you should not pick the subnet that your vm is attached to.

Answers: 3

Answer

Computers and Technology, 23.06.2019 17:00

The camera still is bad even with the new iphone xr and especially in low light it is even worst because you can see the pixels more if its in low light. if all you apple customers want apple to fix this then lets fill there feedback with complaints about the can apple do to fix this issue?

Answers: 1

Answer

Computers and Technology, 23.06.2019 17:30

What are the most commonly found items in the trash according to the municipal solid waste report?

Answers: 1

Answer

You know the right answer?

What is copiedNums' length after the code segment? int[] originalNums = {1,2,3,4,5}; int[] copiedNum...

Questions