Oil and water placed in a jar will separate. Even when shaken and mixed, the oil still separates from the
water.
Which best describes oil and water?
Oil and water are highly soluble because they have
separate chemical properties.
Oil and water have a low solubility because they
have separate chemical properties.
Oil and water are highly soluble because they exert
different pressures
Oil and water have a low solubility because they
exert different pressures.

The answer is B Oil and water have a low solubility because they have separate chemical properties!

Explanation:

For people that don't have ads! :)

I took the test and the assignments!

I hope this helps you out! :)

assuming that your periodic table has eighteen columns, you should highlight   the four elements in the third column from the left of the table.

neutral atoms of elements after calcium contain d electrons. the energy of d orbitals of a particular main shell lies between the energy of the s and p orbitals of the next main shell. for example, electrons in the have energy higher than those in the orbital while lower than those of the orbital.

by the aufbau principle, electrons fill orbitals one at a time, starting from those of the lowest energy. the orbital is therefore filled right after orbitals and before orbitals.  

potassium has electron configuration and calcium . the s orbital of a main shell holds a maximum of two electrons. the next element would thus have the electron configuration and satisfy the requirements.

a neutral atom of the element contains three electrons on top of the most recent noble gas element. it should thus be placed in the third column of the periodic table. both scandium and yttrium would satisfy the conditions. an aufbau diagram indicates that the 4f orbital is filled before the 5d. however, it appears that exceptions exists for both lanthanum and actinium. neutral atoms of the two d-block elements also demonstrate the and should be highlighted as well.

a. the law of proportion states the combination of 2 atoms in a specific ratio to produce multiple compounds such as the given statement of question ‘1st compound contains 88.8 % cu ’ indicates 88.8 g of cu is present along with 11.2 g oxygen in 100 g of compound whereas the statement ‘2st compound contains 79.9 % cu ’ indicates 79.9 g of cu is present along with 20.1 g oxygen in 100 g of compound

1st compound contains 88.8 g cu

for cu

m = 63 g /mol

atomic % = 88.8 /63 = 1.42

for o

m = 16 g /mol

atomic % = 11.2 /16 = 0.7

b. the emperical formula of 1st compound is

cu1.4o0.7

cu2o