srshelton

On site since: 2018-05-16 04:37:19

Age: 27 years

About:

Facebook:

Asked questions: 3

Gave answers: 28

Point: 85

Best answer: 0

Questions

question

Physics, 14.09.2019 03:30

The brakes are applied to a moving van, causing it to uniformly slow down. while slowing, it moves a distance of 40.0 m in 7.70 s to a final velocity...

question

Engineering, 14.09.2019 03:30

Place the following equation in state-space form x+2x+x=0 x(0)=0 x(0)=1...

question

Physics, 14.09.2019 03:30

An object has a charge of-3.8 μc. how many electrons must be removed so that the charge becomes +2.6 μc?...

question

Physics, 14.09.2019 03:30

Astone is thrown directly upward with an initial speed of 9.6 m/s from a height of 12.8 m. after what time interval (in s) does the stone strike the g...

question

Engineering, 14.09.2019 03:30

Ablack 4 cm x 8 cm sheet of metal is heated uniformly with 1000 watts by passing an electric current through it. one face of the rectangle is well ins...

question

Engineering, 14.09.2019 03:30

Aparticle moves along a straight line with a velocity in millimeters per second given by v = 436 - 15tº wheret is in seconds. calculate the net displa...

question

Physics, 14.09.2019 03:30

Gamma rays (γ-rays) are high-energy photons. in a certain nuclear reaction, a γ-ray of energy 0.815 mev (million electronvolts) is produced. compute t...

question

Engineering, 14.09.2019 03:30

What is 220 c in degrees fahrenheit (f)?...

question

Engineering, 14.09.2019 03:30

Apiston at rest, filled with a gas, is adiabatically compressed from an initial state at 790 mm hg and 3 ft' to a final state of 1100 mm hg and 2 ft'....

question

Engineering, 14.09.2019 03:30

Calculate the rate at which body heat is conducted through the clothing of a skier in a steady- state process, given the following data: the body sur...

question

Engineering, 14.09.2019 03:30

Hows many channels of data acquisition will be used for the experiment? a. two b. one c. three d. four...

question

Engineering, 14.09.2019 03:30

An experiment was set-up to measure an unknown fluid's viscosity. two flat plates are separated by a gap of 4.5 mm and move relative to each other at...

question

Engineering, 14.09.2019 03:30

Fluid flowing through a constriction or partially opened valve in a pipe system may develop localized low pressures due to increased velocity. if a pi...

question

Engineering, 14.09.2019 03:30

What is the ratio between the maximum elastic moment, my, and the maximum plastic moment, mp, for a solid rectangular section made from a ductile, ela...

question

Engineering, 14.09.2019 03:30

Abrittle intermetallics specimen is tested with a bending test. the specimen's width 0.45 in and thickness 0.20 in. the length of the specimen between...

question

English, 14.09.2019 03:30

Why does kate chopin choose to tell “the story of an hour” in third person versus from the perspective of a main character? use evidence from the sto...

question

Engineering, 14.09.2019 03:30

Based on results of a tensile test, the flow curve has parameters are the following: strain-hardening exponent=0.40 and strength coefficient =551.6 m...

question

Engineering, 14.09.2019 03:30

How to draw an acceptable free body diagram of a car on a slope? force exerted by the motor is denoted by fm. m = 2000kg. angle of slope = 15degrees....

question

Engineering, 14.09.2019 03:30

Air enters an insulated turbine operating at steady state at 120 psia, 900°r, and 500 ft/s. the exit conditions are 15 psia, 580°r, and 30 ft/s. there...

question

Engineering, 14.09.2019 03:30

A35cm x 35 cm x 35 cm cubical-shaped vacuum chamber with a 4.0 cm aperture is attached to a direct-drive rotary vane pump with a pumping speed of 8.0...