State the methods of nuclear fission waste disposal and the suitability of each method.

Most low-level radioactive waste (LLW) is typically sent to land-based disposal immediately following its packaging for long-term management. This means that for the majority (~90% by volume) of all of the waste types produced by nuclear technologies, a satisfactory disposal means has been developed and is being implemented around the world.


Radioactive wastes are stored so as to avoid any chance of radiation exposure to people, or any pollution.The radioactivity of the wastes decays with time, providing a strong incentive to store high-level waste for about 50 years before disposal.Disposal of low-level waste is straightforward and can be undertaken safely almost anywhere.Storage of used fuel is normally under water for at least five years and then often in dry storage.Deep geological disposal is widely agreed to be the best solution for final disposal of the most radioactive waste produced.

I suggest this site on this subject http://www.world-nuclear.org/information-library/nuclear-fuel-cycle/nuclear-wastes/storage-and-dispo...

Depending on how the continental plates move it can cause a continental scale shift.

Ohm's law tells you that i = v/r where v is equivalent voltage and r is equivalent resistance of the circuit
since all circuits have the same voltage, your question is really asking which circuit has the lowest total resistance, since the lower the resistance, the higher the current
circuit a has a resistance of 5 ohms; circuit c is in series so has a resistance of 10 ohms; circuit b is in parallel and therefore has a resistance of 2.5 ohms (review your notes on adding resistances in parallel and series); therefore b has the highest current