If you place a balloon in the freezer, it will question 16 options: deflate because volume is inversely proportional to temperature stay the same size because there is no relationship between volume and temperature expand because volume is inversely proportional to temperature deflate because volume is directly proportional to temperature

deflate because volume is directly proportional to temperature

Explanation:

Charles' Law: This law states that volume is directly proportional to the temperature of the gas at constant pressure and number of moles.

    (At constant pressure and number of moles)

where,

= initial volume of gas

= final volume of gas

= initial temperature of gas

= final temperature of gas

As volume is directly proportional to temperature, as the balloon is kept in freezer, the temperature would decrease and thus the volume will decrease and it will deflate.

most voltage drop calculators want the distance between the source and destination. then internally, they double it so both the source and return wires are calculated. but you need to know which distance the calculator uses so you're not half of what you should be or double what you should be.

most circuit breakers will not take a #6 directly, so the electrician will have to splice on a smaller pigtail. you also have to upsize the grounding wire when you upsized the ungrounded (hot) wire (see note in 250.122). this will preclude using most cable assemblies, as a cable with #6 copper will most likely only have a #10 grounding conductor. you need a #6 grounding conductor if the circuit is 20a. a #8 cable is no better, as it will have a #10 grounding conductor too. but most 20a breakers will take a #8 directly.

in your related post, you didn't say what type of load this is. if it is a light or heater, voltage drop won't be a big issue. if this is a motor, the current needs are huge at startup and the voltage drop can pose a problem. if this is a motor, knowing if the motor is under much load during startup will answer the voltage drop effect (a saw is easier to start than a compressor).

the answer for apex is the lowest