Physics, 21.03.2022 02:30 sedilei1515

A5 kg cart rolling to the right at 8 m/s runs into a 8 kg cart rolling to the left. After the collision, both
carts are stationary.
What was the original speed of the 8kg cart?

Answers: 3

Show answers

Answers

Answer from: Quest

-first use of geothermal energy occurred more than 10,000 years ago in north america by american paleo-indians

-the first industrial use of geothermal energy began near pisa, italy in late 18th century

-in 1904, italian scientist piero ginori conti invented the first geothermal electric power plant in which steam was used to generate the power

-with the above experiment, the first geothermal plant in usa started in 1922 with a capacity of 250 kilowatts

-however, in 1946 first ground-source geothermal heat pump installed at commonwealth building in portland, oregon

-during the 1960’s, pacific gas and electric began operation of first large scale geothermal power plant in san francisco, producing 11 megawatts

-in 1973, when oil crisis began many countries began looking for renewable energy sources and by 1980’s geothermal heat pumps (ghp) started gaining popularity in order to reduce heating and cooling costs

-as effect of climate change started showing results, governments of various countries joined hands to fight against it, for which kyoto protocol was signed in japan in 1997, laid out emission targets for rich countries and required that they transfer funds and technology to developing countries, 184 countries have ratified it

hope this

Answer from: Quest

It indicates no change in temperature and the process of matter changing its state

Answer from: Quest

answer: the metamorphic rocks are formed when they are exposed to high pressure and high temperatures. this happens when one of the earth's plates comes in contact with the other plate by traveling in opposite directions, straight into each other or slipping under one another. the friction that is caused by this activity results in melting of rocks and when it cools they are known as metamorphic rocks. this process needs a controlled amount of pressure and temperature otherwise it may turn into magma.

Answer from: Quest

higher potential

explanation:

because it is in a high speed so it must move into a of high potential

Another question on Physics

Physics, 21.06.2019 23:30

Part a determine the magnitude of the x component of f using scalar notation. fx f x = nothing lb request answer part b determine the magnitude of the y component of f using scalar notation. fy f y = nothing lb request answer part c determine the magnitude of the z component of f using scalar notation. fz f z = nothing lb request answer provide feedback figure1 of 1a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component. a force vector acting on a ring attached to the ground is shown in the xyz space together with its x, y, and z components lying on the corresponding positive axes. the ring is located at the origin. force f is located in the first octant. f makes an angle of 60 degrees with its x component and an angle of 45 degrees with its y component.

Answers: 2

Answer

Physics, 22.06.2019 12:30

When a vertical beam of light passes through a transparent medium, the rate at which its intensity i decreases is proportional to i(t), where t represents the thickness of the medium (in feet). in clear seawater, the intensity 3 feet below the surface is 25% of the initial intensity i0 of the incident beam. what is the intensity of the beam "10" feet below the surface? (give your answer in terms of i0. round any constants or coefficients to five decimal places.)

Answers: 2

Answer

Physics, 22.06.2019 15:10

Auniform crate c with mass mc is being transported to the left by a forklift with a constant speed v1. what is the magnitude of the angular momentum of the crate about point a, that is, the point of contact between the front tire of the forklift and the ground

Answers: 3

Answer

Physics, 22.06.2019 15:10

Difference between series and parallel circuits

Answers: 3

Answer

You know the right answer?

A5 kg cart rolling to the right at 8 m/s runs into a 8 kg cart rolling to the left. After the col...

Questions