Physics, 14.02.2022 18:50 kitam2871

The figure shows an uncharged conducting cubic shell and a positive point charge Q outside the shell. There are two lettered points W and X inside the shell where the electric field can be measured. The electric field at points W and X are EW and EX, respectively. Point W is at the center of the cubic shell. Outside the shell are points Y and Z where the charge Q can be placed. All four points are along the same line. Which of the following statements is correct? If the point charge is placed at point Y , EW>EX .

Answer A: If the point charge is placed at point Y , E sub W is greater than E sub X .

Answer B: If the point charge is placed at point Y , E sub W is less than E sub X .

Answer C: If the point charge is placed at point Z , E sub W is greater than E sub X .

Answer D: If the point charge is placed at point Z , E sub W is less than E sub X .

Answer E: If the point charge is placed at point Z , E sub W is equal to E sub X .

The figure shows an uncharged conducting cubic shell and a positive point charge Q outside the shel

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 03:50

A30 kg weight lies on top of a massless piston of area a = 0.01 m2 the exterior air is at a (constant) p =1 atm and t = 27 c. the interior gas is 0.4 moles of (ideal) n2 and it has initial temperature 27.00 degrees c. 1. what is the initial pressure in the interior? a. 29.4 kpa b. 130.7 kpa c. 101.3 kpa the next three questions concern what happens when an amount of heat q is slowly added to the interior, raising the piston by 1 mm and raising the interior temperature to 27.40 c

Answers: 3

Answer

Physics, 22.06.2019 06:30

If an atom contains 11 protons in its nucleus, predict the element with the atomic number and electronic configuration. will the number of electrons remain the same during the chemical reaction in such an atom? explain.

Answers: 3

Answer

Physics, 22.06.2019 08:20

A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?

Answers: 3

Answer

Physics, 22.06.2019 10:00

Need people build a dam to create a reservoir that supplies water a nearby city needs. describe two ways this action will likely affect the water cycle in the local environment. (5 points) worth 20 points

Answers: 1

Answer

You know the right answer?

The figure shows an uncharged conducting cubic shell and a positive point charge Q outside the shell...

Questions