Physics, 08.02.2022 15:10 j4ckd4ws

Currently you sell a resistor that has a length of 9 cm, a cross-sectional area of 3 cm2 and uses Metal A with an electrical resistivity of 2 ohm-cm. Unfortunately the melting point of the resistive metal is too low and these resistors keep failing due to melting in operation. You are asked to design a new resistor with the same resistance using Metal B which has a higher melting temperature. Metal B has an electrical resistivity of 6 ohm-cm. What would you recommend for its design

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 09:30

Gasoline comes from petroleum, which is made from ancient living things. petroleum, therefore, contains a type of energy. a. heat b. nuclear c. biological d. chemical potential

Answers: 2

Answer

Physics, 22.06.2019 22:00

It takes a lot of energy to get the temperature of water to increase and eventually boil because water has a high heat.

Answers: 1

Answer

Physics, 22.06.2019 23:00

As seen in a us weather map, the h (or high) and l (or low) symbols indicate regions where surface air pressures are high or low, respectively, compared to surrounding areas. an h is plotted where the air pressure is highest and an l is plotted where the air pressure is lowest. proceeding outward and away from the center of a high pressure system, the air pressure "

Answers: 1

Answer

Physics, 23.06.2019 00:30

Arope has one end tied to a vertical support. you hold the other end so that the rope is horizontal. if you move the end of the rope back and forth with a frequency of 4 hz, the transverse wave you produce has a wavelength of 0.5 m. what is the speed of the wave in the rope?

Answers: 1

Answer

You know the right answer?

Currently you sell a resistor that has a length of 9 cm, a cross-sectional area of 3 cm2 and uses Me...

Questions