Physics, 07.12.2021 21:00 soso585oo

A section of a rollercoaster is shown below. If the 17,500 kg rollercoaster momentarily comes to rest at point A, where it is 19 m in the air, how fast is it going at point D?

Answers: 2

Show answers

Answers

Answer from: Quest

force is based upon mass and acceleration.the statement is not always true.

it can be explained from newton's second law of motion.

as per newton's second law of motion the rate of change of momentum is directly proportional to the applied force and takes place along the direction of force.

mathematically it can be written as -

$f\alpha \frac{dp}{dt}$

⇒ $f= k \frac{dp}{dt}$

here k is the proportionality constant whose value is 1.

$f=\frac{dp}{dt}$

$f= \frac{d[mv]}{dt}$

$f= m\frac{dv}{dt} +v\frac{dm}{dt}$

$f=ma+v\frac{dm}{dt}$ [a is the acceleration=dv/dt]

hence we see that force not only depends on mass and acceleration but also on velocity and rate of change of mass. force f will depend on mass and acceleration only when mass is constant.

hence the statement that force is based upon mass and acceleration is false.

Answer from: Quest

Answer the above statement is ( false );

Answer from: Quest

Hey did u get the answer?

Answer from: Quest

Stars are born within the clouds of dust and scattered throughout most galaxies. a familiar example of such as a dust cloud is the orion nebula. turbulence deep within these clouds gives rise to knots with sufficient mass that the gas and dust can begin to collapse under its own gravitational attraction. as the cloud collapses, the material at the center begins to heat up. known as a protostar, it is this hot core at the heart of the collapsing cloud that will one day become a star. three-dimensional computer models of star formation predict that the spinning clouds of collapsing gas and dust may break up into two or three blobs; this would explain why the majority the stars in the milky way are paired or in groups of multiple stars.therefor, i would say the answer is: dust and gases contract.i hope this ! < 3

Another question on Physics

Physics, 21.06.2019 19:10

Suppose you were asked to find the torque about point p due to the normal force n in terms of given quantities. which method of finding the torque would be the easiest to use?

Answers: 3

Answer

Physics, 21.06.2019 22:30

The percent efficiency of a machine can never be 100% (or greater), because in the real world some energy is always converted into a. heat b. work c. input force d. output force

Answers: 1

Answer

Physics, 22.06.2019 11:30

With the simplified model of the eye, what corrective lens (specified by focal length as measured in air) would be needed to enable a person underwater to focus an infinitely distant object? (be careful-the focal length of a lens underwater is not the same as in air! assume that the corrective lens has a refractive index of 1.62 and that the lens is used in eyeglasses, not goggles, so there is water on both sides of the lens. assume that the eyeglasses are 1.90

Answers: 1

Answer

Physics, 23.06.2019 05:40

What is the change in internal energy if 20 j of heat is released from a system and the system does 50 j of work on the surroundings? a. -70 j b. 30 j c. -30 j d. 70 j

Answers: 2

Answer

You know the right answer?

A section of a rollercoaster is shown below. If the 17,500 kg rollercoaster momentarily comes to res...

Questions