subject
Physics, 07.12.2021 02:20 tatianna341

Given the image here are two the questions i. Which runner, if either, is in the lead when t = 6.0 seconds? Justify your answer qualitatively without any equations.

ii. Justify your answer about which runner, if either, is in the lead when t=6.0 seconds using appropriate equations.


Given the image here are two the questions

i.Which runner, if either, is in the lead when t = 6.0

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 04:00
When the force acting on an object points at least partially in the direction of the motion the work done is considered to be negative
Answers: 2
question
Physics, 22.06.2019 05:10
Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.
Answers: 3
question
Physics, 22.06.2019 11:30
Acaterpillar tries to climb straight up a wall a meter high, but for every 2 cm up it climbs, it slides down 1 cm. eventually, it reaches the top. when it reaches the top, it does not pull itself over so it will slide down 1 cm. what is the total displacement traveled?
Answers: 3
question
Physics, 23.06.2019 07:00
Your physics assignment is to figure out a way to use electricity to launch a small 6.0-cm-long plastic drink stirrer. you decide that you'll charge the little plastic rod by rubbing it with fur, then hold it near a long, charged wire, as shown in figure p23.56 . when you let go, the electric force of the wire on the plastic rod will shoot it away. suppose you can uniformly charge the plastic stirrer to 10 nc and that the linear charge density of the long wire is 1.0 x10-7 c/m. what is the net electric force on the plastic stirrer if the end closest to the wire is 2.0 cm away?
Answers: 1
You know the right answer?
Given the image here are two the questions i. Which runner, if either, is in the lead when t = 6.0...
Questions
question
Mathematics, 18.02.2020 19:19
Questions on the website: 13722363