subject
Physics, 05.12.2021 19:20 sissygirl0807

How much energy will emit 10g of melting point silver until it cools to 60°C. I need a whole solution.. :(

ansver
Answers: 2

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 13:30
6–48 bananas are to be cooled from 24 to 138c at a rate of 215 kg/h by a refrigeration system. the power input to the refrigerator is 1.4 kw. determine the rate of cooling, in kj/ min, and the cop of the refrigerator. the specific heat of banana above freezing is 3.35 kj/kg·8c.
Answers: 3
question
Physics, 22.06.2019 15:40
How does the electric potential energy between two charged particles change if one particle is reduced by a factor of 3? a. increased by a factor of 3 b. it is decreased by a factor of 9 c. it is reduced by a factor of 3 d. it is increased by a factor of 9
Answers: 1
question
Physics, 22.06.2019 16:50
Calculate the first and second velocities of the car with four washers attached to the pulley, using the formulas v1 = 0.25 m / t1 , and v2 = 0.25 m / (t2 – t1) where t1 and t2 are the average times the car took to reach the 0.25 and the 0.50 meter marks. record these velocities, to two decimal places, in table e.
Answers: 2
You know the right answer?
How much energy will emit 10g of melting point silver until it cools to 60°C. I need a whole solutio...
Questions
Questions on the website: 13722360