A flywheel, rotating about its axis at a rate of 4 rev/s is acted upon by a torque of 25 Nm for 10 sec. If the wheel has moment of inertia of 1.2 kgm^2, what would be the speed of the wheel at the end in rev/s?

In a wind tunnel the speed changes as the cross sectional area of the tunnel changes. if the speed in a 6' x 6' square test section is 100 mph, what was the speed upstream of the test section where the tunnel measured 20' x 20'? use conservation of mass and assume incompressible flow. conservation of mass requires that as the flow moves through a path or a duct the product of the density, velocity and cross sectional area must remain constant; i.e., that ova-constant. a model is being tested in a wind tunnel at a speed of 100 mph if the flow in the test section is at sea level standard conditions, what is the pressure at the model's stagnation point? (a) the tunnel speed is being measured by a pitot-static tube connected to a u- tube manometer. what is the reading on that manometer in inches of water? (b) at one point on the model a pressure of 2058 psf is measured. what is the local airspeed at that point?

The coefficient of friction is a number that represents the resistance to sliding between two in contact with one another.

**urgent** roberto plans to use two transformers to reduce a voltage of 120 v to 4 v. he uses a transformer that has 300 coils in the primary winding and 50 coils in the secondary winding. he has four other transformers, as listed in the table. which transformer should roberto use to have an ending voltage of 4 v? a- w b-xc- yd- z