subject
Physics, 20.10.2021 02:20 jasminebrown72

A 20kg object is at rest, and then speeds up to 16m/s. How much work is done on this system.

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 06:30
5submission this assignment is worth 20 points total. you are required to submit the following by next lab: 1. (3 points) determine the equation for the output angular velocity ω2 = θ˙ 2 as a function of θ1, ω1 = θ˙ 1 and α. you must show all your work to receive credit. 2. (2 points) use the result of problem#1 to plot ω2 over 0 ≤ θ1 ≤ 360deg with ω1 = 360deg/sec. do this for α = {10,30}deg. show the results on the same plot and properly label the axes, title, legend. for this you can use matlab or ms excel. 3. (3 points) determine the equation for the output angular acceleration ω˙ 2 and create a plot similar to the one in problem#2. 4. (10 points) submit plots of the results (ω2 and ω˙ 2) obtained from creo/mechanism and compare them to results of problem#2 and problem#3. note that you should do these comparisons for the two cases with α = {10,30}deg. 5. (2 points) provide a brief explanation of the results. did they match? what are the implications as misalignment angle increases?
Answers: 3
question
Physics, 22.06.2019 11:30
With the simplified model of the eye, what corrective lens (specified by focal length as measured in air) would be needed to enable a person underwater to focus an infinitely distant object? (be careful-the focal length of a lens underwater is not the same as in air! assume that the corrective lens has a refractive index of 1.62 and that the lens is used in eyeglasses, not goggles, so there is water on both sides of the lens. assume that the eyeglasses are 1.90
Answers: 1
question
Physics, 22.06.2019 22:50
The chart shows daniela’s run through her race. what is her velocity? 1.5 m/s 2 m/s 2.5 m/s 5 m/s
Answers: 1
question
Physics, 23.06.2019 06:30
Asquare isothermal chip is of width w=5 mm on a side and is mounted in a substrate such that its side and back surfaces are well insulated; the front surface is exposed to the flow of a coolant at tinf=15 °c. from reliability considerations, the chip temperature must not exceed t=85 °c. if the coolant is air and the corresponding convection coefficient is h=200 w/m2 x k, what is the maximum allowable "power" of the chip? if the coolant is a liquid for which h=3000 w/m2 x k, what is the maximum allowable power of the chip?
Answers: 2
You know the right answer?
A 20kg object is at rest, and then speeds up to 16m/s. How much work is done on this system....
Questions
question
Social Studies, 15.07.2019 18:00
Questions on the website: 13722363