Physics, 01.10.2021 20:00 Coolcatfurzy

Theo drew a diagram of a box containing a gas for his science project. His drawing is shown. Theo must also draw a diagram of a box containing a solid. How should Theo draw the box to best represent a solid? A There should be fewer particles with less movement arrows because particles move less quickly in a solid. B There should be fewer particles with more movement arrows because particles move more quickly in a solid. C There should be more particles with more movement arrows because particles move more quickly in a solid. D There should be more particles with less movement arrows because particles move less quickly in a solid.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 03:50

The force acting on a beam was measured under the same operating conditions and a sample of 5 data points was collected. this process was repeated by 3 observers. the pooled standard deviations of these 3 data sets was 1.21. determine the true mean force using all pooled data (with a 95% probability). the result should look like this: true mean = mean +/- margin of error

Answers: 1

Answer

Physics, 22.06.2019 12:00

You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?

Answers: 2

Answer

Physics, 22.06.2019 15:20

Your science teacher brings in a speaker to talk to your class about climate change. during the session, students ask a few questions. which questions are related to the current evidence on climate change

Answers: 3

Answer

Physics, 22.06.2019 18:00

Air enters a gas turbine with two stages of compression and two stages of expansion at 100 kpa and 17°c. this system uses a regenerator as well as reheating and intercooling – the intercooler returns the air to the inlet temperature. the pressure ratio across each compressor is 4 ; 300 kj/kg of heat are added to the air in each combustion chamber; and the regenerator operates perfectly while increasing the temperature of the cold air by 20°c. determine the system’s thermal efficiency. assume isentropic operations for all compressor and the turbine stages and use constant specific heats at room temperature. (0.378)

Answers: 3

Answer

You know the right answer?

Theo drew a diagram of a box containing a gas for his science project. His drawing is shown. Theo mu...

Questions