subject
Physics, 11.06.2021 21:40 11132772

(v) A car A car is pulled with a force of 60.N at angle of 30 ron, the
horizontal. Find the vertical and horizontal components of the applied
force.

ansver
Answers: 2

Another question on Physics

question
Physics, 21.06.2019 16:50
Identify the arrows that show the correct direction of heat transfer. 66°f 112°f 98°f
Answers: 2
question
Physics, 21.06.2019 19:30
A33.1 g copper object is launched from a 1.5 m 30° steel incline positioned on the floor by being pulled up a string attached to a 50.0 g mass suspended vertically over a pulley. the object is projected towards a glass table where it lands when it is at the point along its trajectory with the lowest speed. it comes to a halt when it clears the opposite edge of the table. it then falls and lands on 9 physics texts each 5 cm thick that are stacked on the floor on the opposite side of the table. assume that the table does not have a ledge and the rectangular object experiences 0.05 n of air resistance as it falls towards the books. how far and how long did the object travel and how fast does it hit the books. assume that at the moment the copper object leaves the incline, the massless string and ideal pulley break off
Answers: 2
question
Physics, 22.06.2019 02:30
Agas contained within a piston-cylinder assembly undergoes three processes in series: process 12: compression with pv= constant from 1 bar and 1 liter to 4 bar. process 23: constant pressure expansion to 1 liter. process 31: constant volume calculate the pressure and volume at each state, and sketch the processes on a p-vdiagram labeled with pressure and volume values at each numbered stat
Answers: 2
question
Physics, 22.06.2019 06:00
The frequency of vibrations of a vibrating violin string is given by f = 1 2l t ρ where l is the length of the string, t is its tension, and ρ is its linear density.† (a) find the rate of change of the frequency with respect to the following. (i) the length (when t and ρ are constant) (ii) the tension (when l and ρ are constant) (iii) the linear density (when l and t are constant) (b) the pitch of a note (how high or low the note sounds) is determined by the frequency f. (the higher the frequency, the higher the pitch.) use the signs of the derivatives in part (a) to determine what happens to the pitch of a note for the following. (i) when the effective length of a string is decreased by placing a finger on the string so a shorter portion of the string vibrates df dl 0 and l is ⇒ f is ⇒ (ii) when the tension is increased by turning a tuning peg df dt 0 and t is ⇒ f is ⇒ (iii) when the linear density is increased by switching to another string df dρ 0 and ρ is ⇒ f is ⇒
Answers: 3
You know the right answer?
(v) A car A car is pulled with a force of 60.N at angle of 30 ron, the
horizontal. Find the v...
Questions
question
Mathematics, 11.03.2021 21:00
question
Health, 11.03.2021 21:00
question
Mathematics, 11.03.2021 21:00
question
Mathematics, 11.03.2021 21:00
question
Mathematics, 11.03.2021 21:00
Questions on the website: 13722360