A galvanometer of 50 ohms which gives 2 full scaled deflection from 1mA is to be adopted to measure currents of up to 5A (i) calculate the resistance of the resistor required (ii) if the resistor is made up of two materials of cross sectional area 4 x 10^-4 and resistivity 2 x 10^-6 -2cm. calculate its length​

(science)study the following ocean currents map. an ocean currents map is shown. on the map the locations for san diego, california and savannah, georgia are marked. there is a looping current from the north past san diego and a looping current from the south near savannah which statement is most likely correct about the average temperatures in san diego, california as compared to savannah, georgia? it is higher in savannah because of the cool ocean currents from the south. it is higher in savannah because of the warm ocean currents from the north. it is lower in san diego because of the warm ocean currents from the south. it is lower in san diego because of the cool ocean currents from the north.

Thomas his older brothers, who own a junk yard, on the weekends to earn extra money. he likes to them push broken-down cars to the back of the junk yard because it makes him feel strong. last saturday, they pushed three cars with different weights, and he noticed he used different amounts of force for each one. the cars were the following weights: white car: 2,700 kg red car: 1,500 kg blue car: 2,100 kg think about how much force is needed to move each car. which correctly lists the cars in order from the most to least amount of force needed to move them? a) white, blue, red b) blue, red, white c) red, white, blue d) white, red, blue

A3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular? a 3030 cmcm wrench is used to loosen a bolt with a force applied 0.30.3 mm from the bolt. it takes 6060 nn to loosen the bolt when the force is applied perpendicular to the wrench. how much force would it take if the force was applied at a 3030 degree angle from perpendicular?