subject
Physics, 22.04.2021 19:10 ariyanna029

What is the power dissipated in the resistor in the circuit below? -14W
-2.4
-29W
-60.W


What is the power dissipated in the resistor in the circuit below?

-14W
-2.4
-29W
-60.W

ansver
Answers: 3

Another question on Physics

question
Physics, 21.06.2019 20:20
When many atoms are split in a chain reaction, a large explosion occurs. this is an example of what type of energy conservation
Answers: 2
question
Physics, 22.06.2019 06:40
Light traveling in a medium with a refractive index 1.19 is incident on a plate of another medium with index of refraction 1.79. at what angle of incidence is the reflected light fully polarized?
Answers: 2
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
question
Physics, 22.06.2019 21:10
Two masses are connected by a rope that hangs over a pulley as shown below. the pulley is a uniform cylinder of radius ν‘…=0.381meters and mass ν‘€=3.1ν‘˜ν‘”. initially ν‘š"is on the ground and ν‘š#rests 2.5 meters above the ground. if the system is released, use conservation of energy to determine the speed of ν‘š#just before it strikes the ground. assume the pulley bearing is frictionless.
Answers: 2
You know the right answer?
What is the power dissipated in the resistor in the circuit below? -14W
-2.4
-29W
Questions
Questions on the website: 13722363