Physics, 29.01.2020 17:06 mmaglaya1

Hurry! : ) i am giving 80
levi is installing a heat pump. he installed the pipes two feet deep. he then installed the unit within the house and installed a thermostat inside to regulate the heat pump. lastly, he installed a furnace in the basement. which best describes levi’s errors?
a)the pipes need to be at least six feet deep to avoid the freezing ground, and he did not need to install a furnace.
b)he did not need to install a furnace, and pipes are not necessary in the installation and function of a heat pump.
c)thermostats should be installed directly to the outside unit, and the pipes need to be at least six feet deep to avoid the freezing ground.
d)pipes are not necessary in the installation and function of a heat pump, and thermostats should be installed directly to the outside unit.

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 12:30

Hydrogen atoms are excited by a laser to the =4n=4 state and then allowed to emit. what is the maximum number of distinct emission spectral lines (lines of different wavelengths) that can be observed from this system? 8 6 2 7 4 5 1 3 calculate the wavelength of the 4⟶14⟶1 transition. =λ=

Answers: 2

Answer

Physics, 22.06.2019 14:40

Glass has a hardness that is in the middle of the hardness scale. what is the hardness of glass?

Answers: 1

Answer

Physics, 22.06.2019 16:40

Beryl states that insulation with the smallest possible thermal conductivity is best to keep a house warm in winter, but worst for keeping a house cool in summer. sapphire insists the reverse is true: low thermal conductivity is good in the summer, but bad in the winter. which one, if either is correct? a. beryl, because low thermal conductivity results in low heat transfer. b. beryl, because low thermal conductivity results in high heat transfer. d. sapphire, because low thermal conductivity results in high heat transfer. e. neither, because low heat transfer is desirable both in summer and in winter.

Answers: 2

Answer

Physics, 22.06.2019 19:10

3. a worker pushes a 30.5 kg polished stone along a polished table with a force on bonin a straight line for 5.20 s after starting from rest. there is no friction between thestone and the table. at the end of the table. the stone is hooked to a cable with a lengthof 62.0 cm to rotate it to a rough table to store until they can be picked up. the roughtable has a coefficient of static friction 0.702 with the polished stone. remember that 8= 9.80 m/s2a) what is the speed of the stone when it is hooked to the cable? b) what is the tension in the cable while the stone is rotating? (there is still nofriction)c) how much force is needed to make the stone begin sliding from rest on therough table? ius = 0.70262.0 cm30.5 kg20.5 kg6= 0

Answers: 2

Answer

You know the right answer?

Hurry! : ) i am giving 80
levi is installing a heat pump. he installed the pipes two feet de...

Questions