A charged particle A exerts a force of 2.62 μN to the right on charged particle B when the particles are 13.7 mm apart. Particle B moves straight away from A to make the distance between them 17.7 mm. What vector force does it then exert on A?

Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes.t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.

Afaulty model rocket moves in the xy-plane (the positive y direction is vertically upward). the rocket's acceleration has components ax(t) = ? t2 and ay(t) = ? ? ? t, where ? = 2.50 m/s4 , ? = 9.00 m/s2 , and ? = 1.40 m/s3 . at t = 0 the rocket is at the origin and has velocity ~v0 = v0x ? i + v0y ? j with v0x = 1.00 m/s and v0y = 7.00 m/s. (a) calculate the velocity and position vectors as functions of time. (b) what is the maximum height reached by the rocket? (c) sketch the path of the rocket. (d) what is the horizontal displacement of the rocket when it returns to y = 0?

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?