subject
Physics, 06.04.2021 22:00 steven2669

A 0.2 kg block sliding on a horizontal table slows down from 25 m/s to 20 m/s. How much energy does the block lose due to friction?

ansver
Answers: 3

Another question on Physics

question
Physics, 22.06.2019 15:00
Astudent throws a water balloon with speed v0 from a height h = 1.76 m at an angle θ = 21° above the horizontal toward a target on the ground. the target is located a horizontal distance d = 9.5 m from the student’s feet. assume that the balloon moves without air resistance. use a cartesian coordinate system with the origin at the balloon's initial position. (a) what is the position vector, rtarge t, that originates from the balloon's original position and terminates at the target? put this in terms of h and d, and represent it as a vector using i and j. (b) in terms of the variables in the problem, determine the time, t, after the launch it takes the balloon to reach the target. your answer should not include h. (c) create an expression for the balloon's vertical position as a function of time, y(t), in terms of t, vo, g, and θ. (d) determine the magnitude of the balloon's initial velocity, v0, in meters per second, by eliminating t from the previous two expressions.
Answers: 3
question
Physics, 22.06.2019 19:30
Amass m = 74 kg slides on a frictionless track that has a drop, followed by a loop-the-loop with radius r = 18.4 m and finally a flat straight section at the same height as the center of the loop (18.4 m off the ground). since the mass would not make it around the loop if released from the height of the top of the loop (do you know why? ) it must be released above the top of the loop-the-loop height. (assume the mass never leaves the smooth track at any point on its path.) 1. what is the minimum speed the block must have at the top of the loop to make it around the loop-the-loop without leaving the track? 2. what height above the ground must the mass begin to make it around the loop-the-loop? 3. if the mass has just enough speed to make it around the loop without leaving the track, what will its speed be at the bottom of the loop? 4. if the mass has just enough speed to make it around the loop without leaving the track, what is its speed at the final flat level (18.4 m off the ground)? 5. now a spring with spring constant k = 15600 n/m is used on the final flat surface to stop the mass. how far does the spring compress?
Answers: 3
question
Physics, 23.06.2019 01:40
(8%) problem 12. a bowling ball of mass mb 3 kg 's rolled down the lane with a velocity ofy-2/ m s lt strikes a single remaining pin mp 0.93 kg head on. after the collision the bowling ball has a velocity (in the same direction) of v2 1.1 m/s. = â–˛ 33% part (a) write an expression for the velocity of pin in the horizontal direction after the impact, im ,, 33% part (b) what is the pins speed in ms? 33% part (c) assuming the coefficient of friction s ÎĽ,-0.1. how far in meters could the pin slide before stopping if it doesn't topple?
Answers: 1
question
Physics, 23.06.2019 07:00
Your physics assignment is to figure out a way to use electricity to launch a small 6.0-cm-long plastic drink stirrer. you decide that you'll charge the little plastic rod by rubbing it with fur, then hold it near a long, charged wire, as shown in figure p23.56 . when you let go, the electric force of the wire on the plastic rod will shoot it away. suppose you can uniformly charge the plastic stirrer to 10 nc and that the linear charge density of the long wire is 1.0 x10-7 c/m. what is the net electric force on the plastic stirrer if the end closest to the wire is 2.0 cm away?
Answers: 1
You know the right answer?
A 0.2 kg block sliding on a horizontal table slows down from 25 m/s to 20 m/s. How much energy does...
Questions
question
Mathematics, 17.02.2022 18:50
question
Mathematics, 17.02.2022 18:50
question
Biology, 17.02.2022 19:00
question
Social Studies, 17.02.2022 19:00
question
Mathematics, 17.02.2022 19:00
question
Mathematics, 17.02.2022 19:00
Questions on the website: 13722361