subject
Physics, 24.03.2021 22:30 jlopez113

A 240 V outlet is connected in series with a 150 resistor, a 425 resistor, and a 700 resistor. What is the voltage drop across the 425 resistor?

ansver
Answers: 1

Another question on Physics

question
Physics, 22.06.2019 00:00
How do the measurements of charge at the different locations on the sphere compare to each other? the charge measurements are different at all locations on the sphere. the charge measurements are virtually not the same at all locations on the sphere except for the charge at the very top and at the very bottom that are equal. the charge measurements are virtually the same at all locations on the sphere except for the charge at the very top. at the top, the conductive sphere has a small disk that is made of different material. the charge measurements are the same at all locations on the sphere. what happens to the charge on the conductive sphere when it is connected to a source of charge such as the electrostatic voltage source? nothing will happen because no charge goes around the surface of the sphere. the charge on the conductive sphere spreads out over the surface of the sphere; being greater in some specific locations on the sphere. the charge on the conductive sphere spreads out uniformly over the surface of the sphere. the charge on the conductive sphere spreads out non-uniformly over the surface of the sphere.
Answers: 3
question
Physics, 22.06.2019 14:30
An electromagnet is a device in which moving electric chargers in a coil of wire create a magnet.whats one advantage of using electromagnetic in devices
Answers: 1
question
Physics, 22.06.2019 19:50
The heater element of a 120 v toaster is a 5.4 m length of nichrome wire, whose diameter is 0.48 mm. the resistivity of nichrome at the operating temperature of the toaster is 1.3 × 10-6 ω·m. the toaster is operated at a voltage of 120 v. (a) what is the power drawn by the toaster? (b) if the cost of electricity is 12 ¢ per kilowatt-hour, and it takes 2 minutes to toast bread, how much does it cost for toasted bread? (c) when the heater element is at room temperature, is the resistivity in the nichrome wire greater than, less than, or equal to it’s resistivity when at operating temperature? explain.
Answers: 3
question
Physics, 22.06.2019 23:00
Acommon technique in analysis of scientific data is normalization. the purpose of normalizing data is to eliminate irrelevant constants that can obscure the salient features of the data. the goal of this experiment is to test the hypothesis that the flux of light decreases as the square of the distance from the source. in this case, the absolute value of the voltage measured by the photometer is irrelevant; only the relative value conveys useful information. suppose that in part 2.2.2 of the experiment, students obtain a signal value of 162 mv at a distance of 4 cm and a value of 86 mv at a distance of 5.7 cm. normalize the students' data to the value obtained at 4 cm. (divide the signal value by 162.) then calculate the theoretically expected (normalized) value at 5.7 cm.
Answers: 2
You know the right answer?
A 240 V outlet is connected in series with a 150 resistor, a 425 resistor, and a 700 resistor. What...
Questions
question
Mathematics, 03.03.2021 07:20
question
Mathematics, 03.03.2021 07:20
question
Physics, 03.03.2021 07:20
question
Mathematics, 03.03.2021 07:20
Questions on the website: 13722367