Physics, 22.03.2021 01:00 aalyssag606

if an input of 100 j in pulley system increases potential energy of load 60 J, what efficency of the system?

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 21:20

Which of the following explains why it took so long for the public to accept the negative health effects of smoking? a)people were waiting for counter reasons, and those were presented.b)scientists had not completely finalized their results, which took 30 years.c)cigarettes were cheaply available and media channels were very inefficient.d)cigarette manufacturers were trying hard to bring an alternative into the market

Answers: 3

Answer

Physics, 21.06.2019 22:00

Atank holds 1000 gallons of water, which drains from the bottom of the tank in half an hour. the values in the table show the volume v of water remaining in the tank (in gallons) after t minutes.t(min) 5 10 15 20 25 30v(gal) 694 444 250 111 28 0(a) if p is the point (15, 250) on the graph of v, find the slopes of the secant lines pq when q is the point on the graph with t = 5, 10, 20, 25, and 30.(b) estimate the slope of the tangent line at p by averaging the slopes of two secant lines.(c) use a graph of the function to estimate the slope of the tangent line at p. (this slope represents the rate at which the water is flowing from the tank after 15 minutes.)show all steps.

Answers: 2

Answer

Physics, 22.06.2019 02:00

In which of the following cases is work being done on an object? question 2 options: pushing against a locked door carrying a box down a corridor pulling a trailer up a hill suspending a heavy weight with a strong

Answers: 1

Answer

Physics, 22.06.2019 05:10

Total solidification times of three casting geometries are to be compared: a sphere, a cylinder, in which the length-to-diameter ration - 1.0, and a cube. volume = 1000 cm^3 for all three shhapes, and the same casting alloy is used. a) determine the solidification times of each geometry b) based on the results of part (a), which geometric element would make the best riser? c) if the mold constant = 3.5 min/cm^2 in chvorinov's rule, compute the total solidification time for each casting.

Answers: 3

Answer

You know the right answer?

if an input of 100 j in pulley system increases potential energy of load 60 J, what efficency of the...

Questions