Physics, 17.03.2021 23:50 bigjoebob22

What is an abyssal fan

Answers: 1

Show answers

Answers

Abyssal fans, also known as deep-sea fans, underwater deltas, and submarine fans, are underwater geological structures associated with large-scale sediment deposition and formed by turbidity currents

Explanation:

They are underwater deltas and submarine fans, they are associated with large scale sediment, and formed by turbidity currents.

Answer from: Quest

hello, i am papaguy.

i have found an answer to your question but use it as information.

information: because weak acids/bases have low concentration of hydrogen ions, the addition of water has a large impact on the ph. 2. a difference in 1 unit is a 10x difference in concentration for example; a liquid with ph of 3 is 10x more acidic than a liquid with a ph of 4. therefore, a liquid with a ph of 3 is stronger.

best of luck!

Answer from: Quest

-first use of geothermal energy occurred more than 10,000 years ago in north america by american paleo-indians

-the first industrial use of geothermal energy began near pisa, italy in late 18th century

-in 1904, italian scientist piero ginori conti invented the first geothermal electric power plant in which steam was used to generate the power

-with the above experiment, the first geothermal plant in usa started in 1922 with a capacity of 250 kilowatts

-however, in 1946 first ground-source geothermal heat pump installed at commonwealth building in portland, oregon

-during the 1960’s, pacific gas and electric began operation of first large scale geothermal power plant in san francisco, producing 11 megawatts

-in 1973, when oil crisis began many countries began looking for renewable energy sources and by 1980’s geothermal heat pumps (ghp) started gaining popularity in order to reduce heating and cooling costs

-as effect of climate change started showing results, governments of various countries joined hands to fight against it, for which kyoto protocol was signed in japan in 1997, laid out emission targets for rich countries and required that they transfer funds and technology to developing countries, 184 countries have ratified it

hope this

Another question on Physics

Physics, 22.06.2019 04:00

Which configuration would produce an electric current? a) rotate a coil of copper wire between two magnets. b) connect a wire between a copper and zinc strip sitting in a beaker of water. c) connect a wire to the (+) positive end of a battery and the other end to a light bulb. d) connect a wire to the negative end of a battery and the other end to a light bulb.

Answers: 2

Answer

Physics, 22.06.2019 06:20

Part 1: a magnetic levitation or maglev train rides rails without touching them. explain how this works using your data. include the appropriate magnet drawing in your answer. part 2: two objects are near a bar magnet. one is about 1 cm away, while the other is 6 cm away. compare and contrast the magnetic force that affects each object. use your data to answer the question

Answers: 1

Answer

Physics, 23.06.2019 00:00

You can estimate the degree to which a bond between two atoms is ionic or covalent by calculating the

Answers: 3

Answer

Physics, 23.06.2019 02:10

Find the steady-state temperature at the center of the plate = /2, = /2) for sums of w from n=1 to n=19 (only odd values). find the value of n for which the change in /2, /2) is less than 1% from the value at the previous n. at this point, we consider the solution converged. does the value of the temperature at the center seem reasonable? in this part, the values of x and y are constant scalar values. you should produce a plot of the value of n on the horizontal and the estimate of the temperature at the center of the plate on the vertical. b. using the value of n (or larger) that resulted in convergence in part (a), create a contourf plot of the temperature distribution across the entire plate. use enough spatial subdivisions to create a useful plot. comment on the results. hint: you need to determine what “x” and “y” values to use to make your t matrix. i recommend using a different number of x and y values. use enough x and y values so that the plot is “smooth”.

Answers: 1

Answer

You know the right answer?

What is an abyssal fan...

Questions