Position the loop/bulb at the far right of the sim window. Move the magnet aroundand describehow these factors individuallyaffect the bulb brightness. Also explainfrom the concept of changing flux why you observed what you did. Only describe what you observe and not what you expect to observe. a) Proximity ofnon-movingmagnetto loopalong loop axis (horizontal)(2pts)b) Proximity of moving magnet to loop along loop axis (horizontal)(2pts)c) Vertical motion of magnet just outside loop(2pts)d) Horizontal motion of magnet just outside loop(2pts)e)Number of loops(2pts)f) Magnet Strength(2pts)g)Loop Area (2pts)

Two technicians are discussing a resistance measurement between the can-h and can-l wires. technician a says this measurement should be done with the ignition switch in the "run" position. technician b states that a measurement of 0 ohms indicates an open in the network. which technician is correct?

Calculate the mass of an object that has a momentum of 100kg x m/sec and velocity of 4 m/sec

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.