Physics, 04.03.2021 18:20 nene3210204

Input force- 0.3 m
Output force- 1.2 m

Answers: 1

Show answers

Another question on Physics

Physics, 22.06.2019 01:10

Suppose that two tanks, 1 and 2, each with a large opening at the top, contain different liquids. a small hole is made in the side of each tank at the same depth 1.57 m below the liquid surface, but the hole in tank 2 has 2.49 times the cross-sectional area of the hole in tank 1. (a) what is the ratio ρ1/ρ2 of the densities of the liquids if the mass flow rate is the same for the two holes? (b) what is the ratio rv1/rv2 of the volume flow rates from the two tanks? (c) at one instant, the liquid in tank 1 is 14.9 cm above the hole. if the tanks are to have equal volume flow rates, what height above the hole must the liquid in tank 2 be just then?

Answers: 3

Answer

Physics, 22.06.2019 10:00

In a heat engine if 1000 j of heat enters the system the piston does 500 j of work, what is the final internal energy of the system if the initial energy was 2000 j? 1. write the equation 2.list out your known variables 3.plug the numbers into the equations 4.solve 5.write your solution statement that includes initial energy and final

Answers: 3

Answer

Physics, 22.06.2019 17:00

Air conditioners not only cool air, but dry it as well. suppose that a room in a home measures 5.0m×9.0m×2.4m . if the outdoor temperature is 30 ∘c and the vapor pressure of water in the air is 85 % of the vapor pressure of water at this temperature, what mass of water must be removed from the air each time the volume of air in the room is cycled through the air conditioner? the vapor pressure for water at 30 ∘c is 31.8 torr.

Answers: 3

Answer

Physics, 22.06.2019 23:30

Newton's law of cooling states that the rate of change in the temperature t(t) of a body is proportional to the difference between the temperature of the medium m(t) and the temperature of the body. that is, startfraction dt over dt endfraction equals upper k left bracket upper m left parenthesis t right parenthesis minus upper t left parenthesis t right parenthesis right bracket , where k is a constant. let kequals0.04 left parenthesis min right parenthesis superscript negative 1 and the temperature of the medium be constant, m(t) font size decreased by 3 equivalent font size decreased by 3 294 kelvins. if the body is initially at 369 kelvins, use euler's method with hequals0.1 min to approximate the temperature of the body after (a) 30 minutes and (b) 60 minutes.

Answers: 2

Answer

You know the right answer?

Input force- 0.3 m
Output force- 1.2 m
...

Questions