Physics, 02.03.2021 16:10 dale87

Please help ASAP
I’ll give brainiest

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 07:00

Which articulations allow for greatest range of motion?

Answers: 1

Answer

Physics, 22.06.2019 16:40

Beryl states that insulation with the smallest possible thermal conductivity is best to keep a house warm in winter, but worst for keeping a house cool in summer. sapphire insists the reverse is true: low thermal conductivity is good in the summer, but bad in the winter. which one, if either is correct? a. beryl, because low thermal conductivity results in low heat transfer. b. beryl, because low thermal conductivity results in high heat transfer. d. sapphire, because low thermal conductivity results in high heat transfer. e. neither, because low heat transfer is desirable both in summer and in winter.

Answers: 2

Answer

Physics, 22.06.2019 22:50

Cyclotrons are widely used in nuclear medicine for producing short-lived radioactive isotopes. these cyclotrons typically accelerate h- (the hydride ion, which has one proton and two electrons) to an energy of 5 mev to 20 mev. this ion has a mass very close to that of a proton because the electron mass is negligible—about 1 2000 of the proton’s mass. a typical magnetic field in such cyclotrons is 1.9 t. (a) what is the speed of a 5.0-mev h-? (b) if the h- has energy 5.0 mev and b = 1.9 t, what is the radius of this ion’s circular orbit?

Answers: 1

Answer

Physics, 23.06.2019 07:00

Conventional hot-water heaters consist of a tank of water maintained at a fixed temperature. the hot water is to be used when needed. the drawback is that energy is wasted because the tank loses heat when it is not in use, and you can run out of hot water if you use too much. some utility companies are encouraging the use of on-demand water heaters (also known as flash heaters), which consist of heating units to heat the water as you use it. no water tank is involved, so no heat is wasted. a typical household shower flow rate is 2.50 gal/min (9.46 l/min ) with the tap water being heated from 51.0 ˚f (10.6 ˚c) to 120 ˚f (48.9 ˚c) by the on-demand heater.what rate of heat input (either electrical of from gas) is required to operate such a unit, assuming that all the heat goes into the water?

Answers: 3

Answer

You know the right answer?

Please help ASAP
I’ll give brainiest
...

Questions