1. Answer the following questions: (1+2+1) (a) State what is meant by a vector quantity and give one example.
(b) Fig. 1.1 shows a toy locomotive on a circular track of radius 0.60 m

At time t = 0, the locomotive is at point A. The locomotive travels at a constant speed round the track.
It takes 20 s to travel completely round the track.
(i) Calculate the speed of the locomotive.
(ii) Fig. below shows the variation of the magnitude of the displacement s of the locomotive from A with
time t

Follow these directions and answer the questions. 1. shine a pencil-thin beam of light on a mirror perpendicular to its surface. (if you don't have a laser light as suggested in the video, you can make a narrow beam from a flashlight by making a cone from black construction paper and taping it over the face of the flashlight.) how does the light reflect? how does the relationship of incident to reflected ray relate to the reflection of water waves moving perpendicular to a barrier? 2. shine a pencil-thin beam of light on a mirror standing on a sheet of paper on the table (or floor) so that you can mark the incident ray and reflected ray. (you can support the mirror from the back by taping it to a wooden block.) 3. mark a line on the paper representing the reflective surface. (the reflective surface of a mirror is usually the back edge.) 4. draw a dashed line perpendicular to the mirror surface at a point where the incident and reflected ray meet. this perpendicular is called a normal to the surface. 5. measure the angles between the rays and the normal. the angle of incidence is the angle formed by the incident ray and the normal to the surface. the angle formed by the reflected ray and normal is called the angle of reflection (r). what is the angle of incidence? what is the angle of reflection? 6. repeat for several different angles. (see report sheet for details.) what appears to be the relationship between the angle of incidence and angle of reflection? in science 1204, what was the relationship for these two angles made by the reflection of waves in a ripple tank? 7. roll a ball bearing so that it hits a fixed, hard surface (a metal plate) at several angles (including head-on). observe the way in which the ball bearing reflects. what generalization can you make about how a ball bearing reflects from a wall? have you proved that light can only behave like a wave?

Atwo-stage air compressor operates at steady state, compression 10m^3/min of air from 100 kpa and 300k to 1200 kpa. an intercooler between the two stages cools the air to 300k at a constant pressure of 350 kpa. the compression processes are isentropic. a) calculate the power required to run the compressor, in kw b) compare the result to the power required for isentropic compression from the same inlet state to the same final pressure.

1. what is the relationship between wavelength and the penetrating power of an electromagnetic wave? a) the penetrating power has no relationship to the wavelength. b) the penetrating power increases as the wavelength increases. c) the penetrating power decreases as the wavelength increases. d) the penetrating power decreases as the wavelength decreases. 2. as ice melts and turns into water, the speed of sound through the material would most likely do what? justify your answer. a) the speed would not change because the material is always water. b) the speed of sound would increase because the density of water is less than that of ice. c) the speed of sound would increase because energy is added to ice in order to make it melt. d) the speed of sound would decrease because sound travels faster through solids than liquids. 3.which of these waves need a medium to travel through? a) sound b) x-rays c) infrared rays d) visible light