Sound waves are a type of compression wave. In a compression wave, we have areas of compaction and also areas of rarefaction. In the areas of compression, particles are pushed together and in areas of rarefaction, particle spread apart. Sound waves are different
from light waves in several ways and one is in the type of wave. Light waves are transverse waves that have crests or peaks and
troughs or dips. Which model best shows us a light or transverse wave with very high crests and very low troughs?

Na food processing facility, a spherical container of inner radius r1 5 40 cm, outer radius r2 5 41 cm, and ther- mal conductivity k 5 1.5 w/m · k is used to store hot water and to keep it at 100°c at all times. to accomplish this, the outer surface of the container is wrapped with a 800-w electric strip heater and then insulated. the temperature of the inner surface of the container is observed to be nearly 120°c at all times. as- suming 10 percent of the heat generated in the heater is lost through the insulation, (a) express the differential equation and the boundary conditions for steady one-dimensional heat conduction through the container, (b) obtain a relation for the variation of temperature in the container material by solving the differential equation, and (c) evaluate the outer surface tempera- ture of the container. also determine how much water at 100°c this tank can supply steadily if the cold water enters at 20°c.

You have a resistor and a capacitor of unknown values. first, you charge the capacitor and discharge it through the resistor. by monitoring the capacitor voltage on an oscilloscope, you see that the voltage decays to half its initial value in 2.70 miss . you then use the resistor and capacitor to make a low-pass filter. what is the crossover frequency fc?

Panel bc in fig. p2.76 is semi-circular, with the 3 meter radius and horizontal straight edge through point b. compute (a) the hydrostatic force of the water on the panel, (b) its center of pressure, and (c) the moment of this force about point b. assume atmospheric pressure on the dry side of the panel