Physics, 09.02.2021 06:50 camhappy2005

Could I get help on this question please

Answers: 1

Show answers

Another question on Physics

Physics, 21.06.2019 18:00

Which of the following changes to a pipe would increase the conductance by a factor of 12? 1.quadrupling the length and tripling the radius.2.reducing the length by a factor of and doubling the radius.3.tripling the length and reducing the radius by a factor of .4.reducing the length but a factor of and doubling the radius.

Answers: 3

Answer

Physics, 21.06.2019 22:20

1400 kg car has a speed of 27 m/s. if it takes 7 s to stop the car, what is the impulse and the average force acting on the car?

Answers: 1

Answer

Physics, 22.06.2019 09:40

(a) assume the equation x = at^3 + bt describes the motion of a particular object, with x having the dimension of length and t having the dimension of time. determine the dimensions of the constants a and b. (use the following as necessary: l and t, where l is the unit of length and t is the unit of time.) (b) determine the dimensions of the derivative dx/dt = 3at^2 + b. (use the following as necessary: l and t, where l is the unit of length and t is the unit of time.)

Answers: 1

Answer

Physics, 22.06.2019 11:20

The ultracentrifuge is an important tool for separating and analyzing proteins. because of the enormous centripetal accelerations, the centrifuge must be carefully balanced, with each sample matched by a sample of identical mass on the opposite side. any difference in the masses of opposing samples creates a net force on the shaft of the rotor, potentially leading to a catastrophic failure of the apparatus. suppose a scientist makes a slight error in sample preparation and one sample has a mass 10 mg larger than the opposing sample. if the samples are 12 cm from the axis of the rotor and the ultracentrifuge spins at 70,000 rpm, what is the magnitude of the net force on the rotor due to the unbalanced samples? ( be thorough on your answer)

Answers: 3

Answer

You know the right answer?

Could I get help on this question please
...

Questions