Physics, 27.01.2021 17:40 Haleysaraya1

The temperature at which air becomes saturated with water vapor is called the percent saturation

water content

dew point

relative humidity

Answers: 3

Show answers

Another question on Physics

Physics, 22.06.2019 00:40

The rigid beam is supported by the three suspender bars. bars ab and ef are made of aluminum and bar cd is made of steel. if each bar has a cross-sectional area of 450 mm2, determine the maximum value of p if the allowable stress is (σallow)st = 200 mpa for the steel and ( σallow)al = 150 mpa for the aluminum. est = 200 gpa and eal = 70 gpa.

Answers: 1

Answer

Physics, 22.06.2019 02:30

If a refrigerator is a heat pump that follows the first law of thermodynamics, how much heat was removed from food inside of the refrigerator if it released 380j of energy to the room?

Answers: 1

Answer

Physics, 22.06.2019 05:20

A3.9 g aluminum foil ball with a charge of +4.1×10−9 c is suspended on a string in a uniform horizontal e⃗ field. the string deviates to the right and makes an angle of 30∘ with the vertical. part a part complete what information about the e⃗ field can you determine for this situation? what information about the field can you determine for this situation? only the magnitude of e⃗ only the direction of e⃗ both the magnitude and the direction of e⃗ none of the above previous answers correct part b determine the magnitude of the electric field. express your answer with the appropriate units. e e = nothing nothing request answer part c determine the direction of the electric field. determine the direction of the electric field. to the right to the left away from you toward you

Answers: 3

Answer

Physics, 22.06.2019 14:20

Antireflective coatings on solar cells are often made by applying a thin film of silicon nitride (sinx), which has an index of refractive of 1.2, on the top of the silicon solar cell, which has a refractive index of about 3.5. however, the sun emits radiation of various wavelengths which the solar cell absorbs, and the antireflective coating can only absolutely minimize the reflection of one of these wavelengths. the coating thickness is chosen to reduce the reflection of green/yellow light (e = 2.2 ev), which is the most intense color in the solar spectrum (shown below). which of the following coatings would minimize reflection of green/yellow light? the answer is 820 nm how? what is the angular width of the central maximum of an electron traveling at 2 x 108 m/s going through a single slit of width 1 mm.

Answers: 1

Answer

You know the right answer?

The temperature at which air becomes saturated with water vapor is called the percent saturation

Questions

Physics, 22.02.2021 14:10

What are the uses of a flat magnadur magnet in a school laboratory...